Ok, so here's my list of parts for my el camino build...

-B&M #20412 holeshot 2400 converter
-Comp Cam kit #k12-246-3
- " " rocker arm kit #rpm1301-16
-Edelbrock Air Gap #7501
-Eagle Rotating Assy #B13006E030
-Holley Carb #0-80670
-Hooker Ceramic Coated Headers #2116-1HKR

I am currently installing Motive Gear 3.73:1 Rear gears and a Eaton limited-slip differential. Fuel consumption isn't that much of a concern. The direction in which I am going with this build is a street vehicle with occasional trips to the track. I was wondering if I did my homework right on this list or if there is anything I would need to improve upon. Also, if at all possible, what would be my estimated hp output?  

Is this a big block or small block?

What heads are you using?  

It's a small block and my intentions were to use stock heads ported and polished, which is in the processes. But, I have already done a three angle valve job on the heads.  

hello, im will i want to know is it possible to put in a ls1 in my 96 impala ss.what would be the combination.